Casio E-Con EA-200 Bedienungsanleitung PDF herunterladen (Seite 5)

20021201

8. Press number keys described below to specify what you want to do with the setup you

have configured.

b(Start Setup) ................ Starts sampling using the setup (page 8-1)

c(Save Setup-MEM) ...... Saves the setup (page 6-2)

d(Convert Program) ....... Converts the setup to a program (page 7-1)

k Using Setup Wizard to Configure a PhotoGate Setup

Connection of a Vernier PhotoGate requires configuration of setup parameters that are

slightly different from parameters for other types of sensors.

u To configure a setup for PhotoGate alone

1. Perform the first three steps of the procedure under “To configure an EA-200 setup using

Setup Wizard” on page 2-2.

2. On the “Select Sensor” screen, select [VERN] - [P-Gate] - [None].

• This causes a “Gate Status” screen to appear.

2-3

Using the Setup Wizard

7. Use number keys b through f to specify the unit for the value you specified in step 5.

• When you select a unit, the Final Setup Wizard screen appears on the display.

• “Open” means the photo path is not blocked, while “Close” means the photo path is

blocked.

• The gate status defines what PhotoGate status should cause timing to start, and what

status should cause timing to stop.

Open-Open ...... Timing starts when the gate opens, and continues until it closes and

then opens again.

Open-Close ...... Timing starts when the gate opens, and continues until it closes.

Close-Open ...... Timing starts when the gate closes, and continues until it opens and

then opens again.

Close-Close ...... Timing starts when the gate closes, and continues until it opens and

then closes again.

Final Setup Wizard Screen

1 2 3 4 5 6 7 8 9 10 ... 48 49

Keine Kommentare

Casio E-Con EA-200 Bedienungsanleitung Seite 5