Casio E-Con EA-200 Bedienungsanleitung PDF herunterladen (Seite 4)

20021201

u To configure an EA-200 setup using Setup Wizard

Before getting started...

• Before starting the procedure below, make sure you first decide if you want to start

sampling immediately using the setup you configure with Setup Wizard, or if you want to

store the setup for later sampling.

• See sections 6-1, 7-1, and 8-1 of this manual for information about procedures required to

start sampling and to store a setup. We recommend that you read through the entire

procedure first, referencing the other sections and pages as noted, before actually trying

to perform it.

•To terminate Setup Wizard part way through and cancel the setup, press !i(QUIT).

1. Display the E-CON2 main menu (page 1-1).

2. Press 1(Setup EA-200). This displays the “Setup EA-200” submenu.

3. Press b(Wizard). This displays the “Select Sensor” screen.

4. Press 1 to specify a CASIO sensor, or 2 to specify a Vernier sensor. Select the

sensor you want from the menu of sensors that appears.

• Selecting a sensor (page 2-1) causes a screen for specifying the total sampling time to

appear.

2-2

Using the Setup Wizard

5. Use the number input keys to input the total sampling time. Just input a value. You will be

able to specify the unit (sec, min, hour, day) of the value you input here in step 7 of this

procedure (see "Sensor-specific settings" on page 2-1).

Note

• If you specify a total sampling time value in the range of 10 seconds to 23 hours, 59

minutes, 59 seconds, real-time graphing will be performed during sampling. This is the

same as selecting the Realtime Mode on the “Advanced Setup” screen.

6. After inputting total sampling time value you want, press w. This displays the “Select

Unit” screen.

1 2 3 4 5 6 7 8 9 ... 48 49

Keine Kommentare

Casio E-Con EA-200 Bedienungsanleitung Seite 4