Casio E-Con EA-200 Bedienungsanleitung PDF herunterladen (Seite 13)

20021201

3-5

Using Advanced Setup

4. To change the number of samples setting, move the highlighting to “Number”. Next, press

1 to display a dialog box for specifying the number of samples.

Important!

• When all of the following conditions exist, a “Distance” setting appears in place of the

“Number” setting. See “To configure the Distance setting” below for information about

configuring the “Distance” setting.

• Channel Setup (page 3-2): [VERN] - [P-Gate]- [Pulley]

• Sampling Mode (page 3-4): Clock

•You can specify a value in the range of 10 to 30,000.

• The total sampling time shown at the bottom of the dialog box is calculated by multiply-

ing the “Sampling Interval” value you specified in step 3 by the number of samples you

specify here.

5. To change the warm-up time setting, move the highlighting to “Warm-up”. Next, perform

one of the function key operations described below.

Note

• The “Warm-up” setting will not be displayed on the Sample Setup screen if “Fast” or

“Sound” is currently selected as the sampling mode.

Important!

• When the following condition exists, an “FFT Graph” setting appears in place of the

“Warm-up” setting. See “To configure the FFT Graph setting” below for information about

configuring the “FFT Graph” setting.

• Sampling Mode (page 3-4): Fast

6. After all the settings are the way you want, press w.

• This returns to the Advanced Setup menu.

u To configure the Distance setting

In place of step 3 of the procedure under “To configure Sample Setup settings”, press 1 to

display a dialog box for specifying the distance the weight travels in meters.

• Specify a value in the range of 0.1 to 4 meters.

u To configure the FFT Graph setting

In place of step 5 of the procedure under “To configure Sample Setup settings”, press 1 to

display a dialog box for turning frequency characteristic graphing (FFT Graph) on and off.

To do this: Press this key:

Turn on graphing of frequency characteristics after sampling 1(On)

Turn off graphing of frequency characteristics after sampling 2(Off)

To do this: Press this key:

Have the warm-up time for each sensor set automatically 1 (Auto)

Input a warm-up time, in seconds, manually 2 (Manual)

Disable the warm-up time 3 (None)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 48 49

Keine Kommentare

Casio E-Con EA-200 Bedienungsanleitung Seite 13