Casio IT-2000W Spezifikationen PDF herunterladen (Seite 85)

5.2 Installation of MS-Windows

As explained on the previous page, it is necessary to move (copy) some files onto the write-permit

drive before booting MS-Windows. This section will describe this copy operation The following is

an example of manually installing necessary files so that the user can determine the contents.

A utility program (WINST.EXE) can be used to reduce the work load.

For more information about this installation utility refer to Chapter 9.10 "Windows Installation

Utility".

5.2.1 Demonstration Installation

For this terminal it is recommended to initiate the application program at the same time

MS-Windows is started. The program manager can also be initiated during the development of

application programs or for the purpose of demonstration. To initiate the program manager for the

above purpose use the following procedure:

Create the D: WINDOWS directory.

Copy the entire content of E: WINDOWS LOCAL onto the created directory.

The following files are to be copied:

WIN.COM WIN.INI

WIN.CLN WFWSYS.CFG

SYSTEM.INI MOUSE.INI

PROGMAN.INI SERIALNO.INI

CONTROL.INI MAIN.GRP

ACCESSOR.GRP STARTUP.GRP

WINVER.EXE SYSTEM.CLN

SHARES.PWL

Create the CONFIG.SYS and AUTOEXEC.BAT files. Remember to add "D: WINDOWS;

E: WINDOWS" to the existing path. Then specify “win.com” to boot MS-Windows at the end

of the AUTOEXEC.BAT file.

Copy the created CONFIG.SYS and AUTOEXEC.BAT files onto D: .

The above procedures complete the demonstration installation of MS-Windows. MS-Windows will

be automatically booted if the terminal is re-started by pressing the RESET switch.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 296 297

Keine Kommentare

Casio IT-2000W Spezifikationen Seite 85