Casio DT-X8 Series Bedienungsanleitung PDF herunterladen (Seite 49)

Note:

Follow the steps below to set the terminal in the virtual OFF mode.

1. Set the virtual OFF mode effect with SysSetVirtualOffMode function.

2. Set "Turning off the power with Power key" effect with SysDisablePowerOff

function or SysSetVirtualOffModeEx function.

3. Once the above settings have been made, the power driver will issue either one of the

messages below depending on the terminal's condition when the Power key is pressed.

During the power is kept turned off;

• PBT_APMSUSPEND(0x0004) from WM_POWERBROADCAST(0x0218)

(In ordinary operation mode, the power driver will not issue this message, but only

in the virtual OFF mode.)

During the power is kept turned on;

• PBT_APMRESUMESUSPEND(0x0007) from WM_POWERBROADCAST

4. In a process for the received messages above, be sure to include the settings below.

In case SysDisablePowerOff function is used;

Each setting below must be set up individually.

- Display power control

- Key input control (See step no. 5.)

- Sound control

- Buzzer control

- Vibrator control

- LED control

In case SysSetVirtualOffModeEx function is used:

Setting for "Enable" or "Disable" for the virtual OFF mode

5. For "Key input control", there are keys that cannot be set disabled. For those keys, use

SysDisablePowerOff function and OBRClose function for the laser models (or

IMGDeinit function for the imager models) to disable the Power key and Trigger keys

respectively.

6. In case VDET1 occurs while the virtual OFF mode is active, the battery remaining

capacity will run down quickly causing VDET2 to occur if the power to the WLAN

module is kept on. To avoid battery's power consumption, it is recommended to turn off

the power on the terminal with SysPowerOff function as soon as

PBT_APMBATTERYLOW (0x0009) message of WM_POWERBROADCAST is issued

at a time when VDET1 occurs.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 170 171

Keine Kommentare

Casio DT-X8 Series Bedienungsanleitung Seite 49