Casio BN-10 Bedienungsanleitung

121Data communications capabilities let you transfer data between two CASIOPV Units, between a PV Unit and a BN-10/BN-20 Unit, or between a PVUnit and

130To send data from the PV Unit to the BN Unit1. After connecting the two units, turn on the PV Unit.• BN Unit power should still be off at this time

131Chapter 10 Data Communication6. Tap Set.7. Tap the check boxes to specify the data you want to send (checked) andthe data you do not want to send (

132• The following shows the relationship between data when sent from thePV Unit to a BN Unit.To receive data from the BN Unit on the PV Unit1. Perfor

133Chapter 10 Data Communication3. Tap Set.4. Tap the check boxes next to specify the data you want to receive (checked)and the data you do not want t

134• Transferring data from the PV-200A/PV-250X/PV-400A/PV-450X to theBN Unit causes all euro symbols to be replaced by spaces.• The following shows t

135Chapter 10 Data Communication4. Use an optional SB-90 9-9 pin connector to connect the PV Unit cradleto the other unit’s cable.To make communicatio

1363. Tap the Menu Bar icon to display the menu bar, and then tap System –Data communication.4. Tap the button next to SF/CSF/NX.5. Press the button n

137Chapter 10 Data CommunicationTo receive data from an SF/CSF/NX Series Unit1. After connecting the two units, turn on the PV Unit.2. Display the lis

138Notes• Data communication can be interrupted at any time by tapping Esc.This causes the message Stopped! to appear on the display of the PVUnit.• T

122Using the CradleThe PV Unit comes with a cradle that helps to make data communications quickerand easier. The following procedures describe how to

123Chapter 10 Data CommunicationTo detach the PV Unit from the cradle1. Turn off PV Unit power.2. Lift up on the PV Unit while holding down the cradle

1243. Use an optional SB-90 9-9 pin connector to connect the two cradles toeach other.• All data communication settings must be made on only one of th

125Chapter 10 Data Communication3. Tap the Menu Bar icon to display the menu bar, and then tap System –Data communication.4. Tap the button next to Po

1268. After everything is the way you want it, tap Set.9. Turn on the power of the terminal unit and then press the Start buttonon its cradle to start

127Chapter 10 Data Communication3. Tap Set.4. Tap the check boxes to specify the data you want to receive (checked)and the data you do not want to rec

128Notes• The above procedures can be used to send or receive all data in specificmodes only. You cannot send or receive individual data items.• Data

129Chapter 10 Data CommunicationData Communications Between a PV Unit anda BN UnitThis section describes how to set up and communicate between a PV Un