Casio XJ-SK650 Einstellungsanleitung

Dual Projection SystemXJ-SK650Dual Projection SystemXJ-SK650EFSSetup GuideEnglish Be sure to read the precautions in the “YA-S10 Setup Guide” that co

E-9Getting Ready7. On the remote controller, press the [MENU] key to display the setup menu, and then configure the settings below in the indicated se

Getting ReadyE-10After you finish configuring the initial settings of the two projectors, perform the procedure below to configure initial Control Box

E-11Getting ReadyUse the procedure in this section to adjust the projected images of the two projectors so they are approximately the same size and at

Getting ReadyE-125. Perform the steps below to adjust the position and size of the Projector B image so it slightly runs off the edges of the target s

E-13Getting Ready8. On the “Image Shaping” menu that appears, select “Adjust Image Position” and then press the [ENTER] key.z This will project two ad

Getting ReadyE-1415.Next, perform the procedure in the separate YA-S10 Setup Guide under “Shaping the Image to Match the Projection Screen”.Important!

E-15Product SpecificationsApproximate Dimensions (Excluding Projections)* See page E-7 of this manual for information about Storage Box (A) and Storag

CAN ICES-3(B)/NMB-3(B)GUIDELINES LAID DOWN BY FCC RULES FOR USE OF THIS UNIT IN THE U.S.A. (not applicable to other areas).NOTICEThis equipment has be

Printed in ChinaImprimé en ChineMA1302-ARJA528057-001

E-1XJ-SK650 Overview... E-2Unpacking ...E-2General Guide ...

E-2XJ-SK650 OverviewThe XJ-SK650 Projector System uses a Control Box to sync two projectors so their output looks and acts as if it is coming from a s

E-3XJ-SK650 OverviewGeneral GuideCabinetControl BoxProjectorsFocus ringZoom ring

E-4Getting ReadyThe Projector System can be placed on a flat surface or it can be ceiling mounted.Placing the Projector System on a Flat SurfaceAfter

E-5Getting ReadyLocation Precautionsz Use a conveniently located power outlet that you can reach easily when you need to unplug the power cord.z Make

Getting ReadyE-6Ceiling InstallationThe Projector System can be hung from a ceiling. When doing so, mount it in an inverse (upside down) configuration

E-7Getting ReadyWire the Control Box and two projectors inside the Cabinet as shown in the illustration below.When connecting the Control Box to a pro

Getting ReadyE-8Load two AAA-size alkaline batteries into each of the remote controllers: one YT-200 Control Box remote controller, one YT-120 project